806 (Up to 98MY) PLIP PROGRAMMING

1. Turn the Ignition switch to accessory position using the key, without the remote plip attached.

2. Hold the Plip key towards the receiver at the front of the vehicle.

3. Press the large plip button then the small plip button on the remote.

4. Repeat for the second Plip key if required.

5. Turn ignition OFF.

After 5 seconds the Plip should now operate.

806(From 98MY) PLIP PROGRAMMING
1. Turn the Ignition switch to the accessory position using the key without the remote plip attached.

2. Hold the Plip key close to the central locking receiver mounted in the roof console.

3. Press the large plip button and then the small plip button on the remote.

4. Repeat for second Plip key if required.

5. Turn the ignition OFF.

6. After 5 seconds the Plip should now operate.